3 in 1 laser welding machine instruction manual

How to use  3 in 1 laser welding machine?

1. Cautions ● Note : conventional gas : compressed air ( it needs to have oil and water filtration)And after dry ing

2. ● Do not use too viscous liquid for cooling water medium

3. ● A ir pressure Cutting : 0.8-1.0 Mpa ，C leaning/Welding : 0.2-0.3 Mpa， Gas :argon/nitrogen/compressed air ，Dry ing and O il-water filtration is required

4. ● For rep lacing lense, under Dust-free environment. Keep lens clean and clear. ≥ 95% alcohol for cleaning lens.

5. ● 1 kw/ 1 . 5 kw/ 2 kw Voltage 2 2 0 v ± 1 0 v 6 0 hz sing le phase

6. ● water cooler 220v ± 10v sing le phase 60hz

7. ● 3000w Voltage 380v ± 10v 60hz Three-phase electric

8. ● L connects live wire, N connects neutral wire, PE ground wire

9. ● Before adding water, p lease check and ensure all connections fasten.

   

   1.Power on /off operation When the system is powered on,the power indicator is on,and press "on/off"to control the system on and off.

   Press "on/off"to start the machine.

   Press "on/off"for 5 seconds to turn off the machine

       2.2.Parameter setting After pressing "menu"in the main interface, enter the main menu interface,press "up"and "down"to select the sub-menu,press "menu"to enter the sub-menu,and press "on/off"to return to the upper menu.

After entering the root menu,press "up"and "down"to adjust the parameter value,and press "menu"to save the parameter.If the key is not pressed within 10 seconds during the setting process,it will automatically return to the main interface.

There are two feed wheels in one set.There are two slots on the wire feed roll,which should be installed one by one.

The wire core diameter should be matched with the width of the slot by 1:1.

Usually the wire feed roll has two slots of different specifications shown in the following figure.

During installation,the two slots should be in the same horizontal line.

Change wire feed roll Step 

1:rotate and loosen two handles locking the wire feed roll Step

 2:swing forward 90°and loosen it downward Step 

3:rotate and loosen the nut locking the wire feed roll and changeit

Rotate the the handle on the wire pressing wheel.

The scale on the handle can help to  adjust wire feeding to make the wire feeding on the same horizontal line.

Step 1: align the wire tube with the wire nozzle to stall it.Tight the screw to fix it. 

Step 2:the wire nozzle should be matched with copper nozzle by 1:1 according to the size of the wire core diameter selected by customers.